Computer courses · Tools for technicians · Tech support Call 859-878-2615 WhatsApp Send a message

Home · Blog

Gabak USA YouTube

Blog

Practical tech articles from the Gabak USA YouTube channel: each post explains one video step by step, with the video included.

How to stake crypto without a minimum or a server using Binance.US

· By Gabriel

How to stake crypto without a minimum or a server using Binance.US

Staking your own validator can require a lot of coins and a computer running 24/7. This step-by-step guide shows how staking was done on Binance.US with about $3 of Polkadot (DOT): open Staking, buy the coin, choose the amount, enable auto-restake, check rewards and the unstaking period, confirm and track the results weeks later.

Read article →
How to fix a MaxxAir Maxx Fan that won't turn on (easy $10 repair)

· By Gabriel

How to fix a MaxxAir Maxx Fan that won't turn on (easy $10 repair)

When the Maxx Fan logic board dies, swap it for a cheap DC motor speed controller with a built-in speed knob and direction switch. Remove the old board, mount the new controller through a small hole, connect power in and motor out, extend the wires with crimped butt connectors and heat shrink, then test.

Read article →
How to swap a Lenovo motherboard for a standard one and keep the same parts

· By Gabriel

How to swap a Lenovo motherboard for a standard one and keep the same parts

Motherboard swap walkthrough: remove the old Lenovo board (tricky GPU latch, non-standard USB, audio and 14-pin power connectors), fit the I/O shield, move standoffs, install the old CPU carefully in the new Machinist board, add the heatsink, wire 24-pin, CPU power, SATA, USB, audio and front-panel pins, add a video card and test before cable management. Windows 10 usually doesn't need a reinstall.

Read article →
How to cut and modify a computer case fast with a plasma cutter

· By Gabriel

How to cut and modify a computer case fast with a plasma cutter

Computer case mod: the drives couldn't come out past the RAM and CPU heatsink, so I cut the front of the case with a Hypertherm plasma cutter (ground clamp on the chassis, metal sheet under the work). The drives came out easily and the PC still posted, but on an important computer remove all fragile parts first.

Read article →
WhatsApp Visitors today: — This month: — Total: —